Boiler Inspection And Maintenance; Why Is Regular Maintenance Important; Testing The Flue System, Including Combustion Air, Air Inlets And Ventilation Openings; Inspection Of The Boiler And Burner - Buderus Logano GA124 Installation And Maintenance Instructions Manual

11

Boiler inspection and maintenance

11 Boiler inspection and maintenance

11.1 Why is regular maintenance important?

Heating systems require regular maintenance for the
following reasons:
– To maintain high efficiency operation and to operate
the heating system economically (low fuel
consumption).
– To sustain safe operation.
– To maintain combustion at an environmentally
friendly level.
All maintenance work must be carried out by a qualified
customer service technician only. When replacing
components use only parts approved by Buderus.
Maintenance is required once a year. Record the results
of the inspection in the protocol at
USER NOTE
Spare parts can be ordered from your
local distributor.

11.2 Testing the flue system, including combustion air, air inlets and Ventilation openings

Check the venting system, including the combustion air,
inlet and outlet openings. All faults must be repaired
immediately.
Make sure that the combustion air feed and the inlets
and outlets are not blocked at any point.

11.3 Inspection of the boiler and burner

1. Visually check the boiler and burner for external dirt.
2. Check burner box, supply air hose and burner rods
for dirt.
3. Check air supply hose for damage and replace if
necessary.
4. If dirt is found, clean boiler and burner.
48 Installation and maintenance instructions Logano GA124 special gas-fired boiler • Issue 04/2005
page 59.
We reserve the right to make any changes due to technical modifications.