Care And Maintenance - Pride Mobility Jazzy EVO Series Owner's Manual

V I I . C A R E A N D M A I N T E N A N C E

CARE AND MAINTENANCE

Your Jazzy is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance checks. You
can perform some of these checks, but others require assistance from your authorized Pride Provider. Preventive
maintenance is very important. If you follow the maintenance checks in this section as scheduled, you can help
ensure that your power chair gives you years of trouble-free operation. If you have any doubt as to your power
chair's care or operation, contact your authorized Pride Provider.
WARNING! Do not service the power chair when the seat is occupied.
Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp areas
of any kind.
WARNING! Direct or prolonged exposure to water or dampness could cause the power
chair to malfunction electronically and mechanically. Water can cause electrical
components to corrode and the chair's frame to rust. Power chairs should be examined
periodically for signs of corrosion caused by water exposure, bodily fluids exposure,
or incontinence. Damaged components should be replaced or treated immediately.
Should your power chair come in contact with water:
1. Dry your power chair as thoroughly as possible with a towel.
2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your power chair again.
4. If any inconsistencies are found, take your power chair to your authorized Pride Provider. Power chairs that
are frequently exposed to sources of water, such as incontinence, should be inspected often for corrosion and
electronic components may need to be replaced frequently.
Temperature
„ Although your power chair can withstand short-term storage temperatures between -40°F (-40°C) to 149°F
(65°C), it is recommended that long-term storage temperatures be between -13°F (-25°C) and 122°F (50°C).
Ideal storage conditions are 68°F (20°C) to 70°F (21°C) wherever possible, but we realize that is not always
feasible due to different climates and environments.
„ In extremely cold temperatures the batteries may freeze. The specific temperature at which they freeze depends
on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., AGM or Gel-Cell).
General Guidelines
„ Avoid knocking or bumping the controller, especially the joystick.
„ Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.
„ Keep the controller clean.
„ Check all connectors to ensure that they are all tight and secured properly.
„ Make sure pneumatic tires are inflated to the psi/bar/kPa air pressure rating indicated on the tire.
WARNING! Make sure your tires are inflated to the psi/bar/kPa air pressure rating indicated
on the tire for pneumatic tires. Do not underinflate or overinflate your tires. Low pressure may
result in loss of control, and overinflated tires may burst. Overinflating tires can cause them to
explode.
WARNING! Do not use a high pressure hose to inflate your tires.
„ Use a rubber conditioner on the tire sidewalls to help preserve them.
WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the
tires slippery and cause your power chair to skid.
28 www.pridemobility.com Jazzy EVO Series