Getting Started; Accessory List; Location Of Controls; Turning Power On Or Off - Alpine IVA-W505 Owner's Manual

Getting Started
Accessory List
• Head unit 1
• Power cable 1
• Mounting sleeve 1
• Bracket key 2
• Flush Head Screw (M5x8) 6
• Screw (M5x8) 8
• Remote control 1
• Battery (CR2025) 1
• Face plate 1
• Mounting Position Seal 2
• Slot Securing Screw (M2 x 4)* 2
• Pre OUT Cable 1
• AUX I/O Cable 1
• AV extension cable 1
• USB extension cable 1
• USB 30P cable 1
• Owner's Manual 1 set
*
To customers who do not use an optional portable navigation:
Ifnecessary, secure the slot panel with this screw.
Optional Remote Control Interface Box
This unit is operable using the vehicle's secondary radio controls.
An Alpine Remote Control Interface Box (optional) is required. For
details, contact your Alpine dealer.
Location of Controls
G)
Remote Sensor
Point the supplied remote control transmitter towards the
remote sensor within a range of 2 meters.
®
V / /\.
button
Press to adjust the volume.
@
MUTE button
Lowers the volume by 20 dB instantly. Press the button
again to cancel.
@
*
(OPTION) button
Press to recall the setting which is set in "Setting the VISUAL
Soft Button" (page 39).
If "V. SEL" is set, the VISUAL SETUP screen will be recalled.
If "SAT" is set, the weather channel or traffic channel will be
recalled (when the XM or SIRIUS Receiver Box is
connected).
If "TEL" is set, the TEL Bluetooth screen will be recalled
(when the optional Bluetooth Box is connected).
@
IMPRINT/AUDIO button
Press to recall the IMPRINT operation screen. (When the
optional IMPRINT audio processor (PXA-H100) is
connected).
Pressing and holding for at least 2 seconds will recall the
AUDIO SETUP screen.
@
SOURCEI<!> button
Turns the power on. Press and hold for at least 2 seconds to
turn the power off.
Recalls the SOURCE selection screen.
(j)
OPEN button
Recalls the EJECTfTlLT screen.
If the disc does not eject after touching [EJECT) of DISC,
press and hold OPEN for at least 3 seconds.
@
RESET switch
Be sure to press the RESET switch when using the unit for
the first time, after installing the CD changer, after changing
the car battery, etc.
Turn off the unit power, press RESET with a ballpoint pen or
similar pointed object.
®
DOCK indicator
Lights when a portable navigation device is inserted into the
unit.
About the button descriptions used in this Owner's
Manual
• The buttons found on the face ofthe unit are expressed in bold
(e.g. SOURCEIcJ). The buttons found on the touch-screen
display are shown in bold within brackets, [ ] (e.g. [SOURCE]).
• This Owner's Manual explains mainly the function of soft
buttons, when a soft button and a unit button have the same
function.
Turning Power On or Off
Some ofthis unit's functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Press SOURCEI<!> to turn on the unit.
• The unit can be turned on by pressing any button.
2
Press and hold SOURCEI<!> for at least 2 seconds to
turn off the unit.
• Some operation ofthe unit cannot be performed while the vehicle is
in motion. In this case, be sure to first stop your vehicle and apply the
parking brake, then perform the operation.
• The IVA- W505 is a precision device. With gentle handling, its unique
capabilities can be enjoyed for a long time.
ii-EN
Getting Started
Accessory List
• Head unit 1
• Power cable 1
• Mounting sleeve 1
• Bracket key 2
• Flush Head Screw (M5x8) 6
• Screw (M5x8) 8
• Remote control 1
• Battery (CR2025) 1
• Face plate 1
• Mounting Position Seal 2
• Slot Securing Screw (M2 x 4)* 2
• Pre OUT Cable 1
• AUX I/O Cable 1
• AV extension cable 1
• USB extension cable 1
• USB 30P cable 1
• Owner's Manual 1 set
*
To customers who do not use an optional portable navigation:
Ifnecessary, secure the slot panel with this screw.
Optional Remote Control Interface Box
This unit is operable using the vehicle's secondary radio controls.
An Alpine Remote Control Interface Box (optional) is required. For
details, contact your Alpine dealer.
Location of Controls
G)
Remote Sensor
Point the supplied remote control transmitter towards the
remote sensor within a range of 2 meters.
®
V / /\.
button
Press to adjust the volume.
@
MUTE button
Lowers the volume by 20 dB instantly. Press the button
again to cancel.
@
*
(OPTION) button
Press to recall the setting which is set in "Setting the VISUAL
Soft Button" (page 39).
If "V. SEL" is set, the VISUAL SETUP screen will be recalled.
If "SAT" is set, the weather channel or traffic channel will be
recalled (when the XM or SIRIUS Receiver Box is
connected).
If "TEL" is set, the TEL Bluetooth screen will be recalled
(when the optional Bluetooth Box is connected).
@
IMPRINT/AUDIO button
Press to recall the IMPRINT operation screen. (When the
optional IMPRINT audio processor (PXA-H100) is
connected).
Pressing and holding for at least 2 seconds will recall the
AUDIO SETUP screen.
@
SOURCEI<!> button
Turns the power on. Press and hold for at least 2 seconds to
turn the power off.
Recalls the SOURCE selection screen.
(j)
OPEN button
Recalls the EJECTfTlLT screen.
If the disc does not eject after touching [EJECT) of DISC,
press and hold OPEN for at least 3 seconds.
@
RESET switch
Be sure to press the RESET switch when using the unit for
the first time, after installing the CD changer, after changing
the car battery, etc.
Turn off the unit power, press RESET with a ballpoint pen or
similar pointed object.
®
DOCK indicator
Lights when a portable navigation device is inserted into the
unit.
About the button descriptions used in this Owner's
Manual
• The buttons found on the face ofthe unit are expressed in bold
(e.g. SOURCEIcJ). The buttons found on the touch-screen
display are shown in bold within brackets, [ ] (e.g. [SOURCE]).
• This Owner's Manual explains mainly the function of soft
buttons, when a soft button and a unit button have the same
function.
Turning Power On or Off
Some ofthis unit's functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Press SOURCEI<!> to turn on the unit.
• The unit can be turned on by pressing any button.
2
Press and hold SOURCEI<!> for at least 2 seconds to
turn off the unit.
• Some operation ofthe unit cannot be performed while the vehicle is
in motion. In this case, be sure to first stop your vehicle and apply the
parking brake, then perform the operation.
• The IVA- W505 is a precision device. With gentle handling, its unique
capabilities can be enjoyed for a long time.
ii-EN