Getting Started; Accessory List; Location Of Controls; Turning Power On Or Off - Alpine IVE-W535ABT Owner's Manual

Getting Started

Accessory List

• IVE-W535ABT/IVE-W535EBT...............................................1
• Power cable.........................................................................1
• Flush head screw (M5×8)....................................................6
• Screw (M5×8) ......................................................................8
• AUX/PRE OUT cable ...........................................................1
• Camera cable ......................................................................1
• USB extension cable ...........................................................1
• Microphone..........................................................................1
• Mounting sleeve ..................................................................1
• Face plate............................................................................1
• Bracket key..........................................................................2
• Carrying bag .......................................................................1
• Owner's Manual ..............................................................1set

Location of Controls

(Release) button
Use this button to remove the front panel.
Remote Sensor
Point the remote control transmitter towards the remote
sensor within a range of 2 metres.
(My Favorites) button
The My Favorites screen for registered User 1 is displayed.
Press and hold this button at least 3 seconds to switch to
User 2.
(SOURCE) button
Displays the Audio/Visual screen. If the Audio/Visual screen
is already displayed, changes the source.
(PHONE) button
Recalls the Telephone Menu screen.
When a hands-free phone is connected, press and hold for
at least 3 seconds to switch to the call history screen.
(AUDIO SETUP) button
Displays the "Setting the Balance/Fader/Subwoofer"
screen.
Press and hold for at least 3 seconds to activate the Sound
Setup selection mode.
Rotary encoder/MUTE/C button
Adjust the volume by turning to the left or right.
Press to activate /deactivate the mute mode.
Press and hold for at least 3 seconds to turn the power off.
c (Eject) button
Ejects a disc.
DISC Slot
• For details of the RESET switch, refer to "Initial System Start-Up"
(page 17).
Optional Remote Control Interface Box
This unit is operable using the vehicle's secondary radio controls.
An Alpine Remote Control Interface Box (optional) is required. For
details, contact your Alpine dealer.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote control sensor.
About the button descriptions used in this Owner's
Manual
The buttons found on the face of the unit are expressed in
bold (e.g. (My Favorites)). The buttons found on the
touch-screen display are shown in bold within brackets, [ ]
(e.g. [ ]).

Turning Power On or Off

Some of this unit's functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Turn the ignition key to the ACC or ON position.
The system turns on.
• When turned on, the system displays the last mode screen that
was displayed before the ignition key was turned off. For
example, if the unit is in radio mode when ignition is turned off,
it will remain in radio mode when ignition is turned back on.
2
Press and hold the Rotary encoder for at least 3
seconds to turn the power off.
• The unit can be turned on by pressing any button on the unit, except
(Release).
• The IVE-W535ABT/IVE-W535EBT is a precision device. Careful
handling of the unit should provide you with years of trouble-free
operation.
15
-EN