Table of Contents
Advertisement
The internal display now shows the lyrics of the
selected song (4 lines at a time) and the chords of the
song (only for SMF files).
4.
At the end of the song, press and hold the
[EXIT] button to return to the main page.
NOTE
The internal display always shows four lines of lyrics and
the chord symbols (this cannot be changed).
External Lyrics
This is, in fact, a switch that allows you to cancel ("Off")
or activate ("On") the display of song lyrics on an exter-
nal screen.
'Performance Edit' parameters
The following parameters can be set for each Perfor-
mance memory:
Parameter/Group
Explanation
Tone Part View
This is where you can edit settings
related to Tones. See page 59.
Tone Part MFX
Contains the effects parameters for the
keyboard parts (LWR, UP2, UP1). See
page 63.
Rhythm Parts
This group contains all parameters of the
rhythm parts. See page 64.
Split
This parameter allows you to change the
split point, i.e. the separation between
the lower and upper keyboard zones. See
page 65.
Scale Tune Switch This parameter allows you to specify
which parts should be affected by the
"Scale Tune" setting (page 65).
Scale Tune
Use these parameter to change the tun-
ing system (page 65). You can also press
and hold the USER SCALE buttons (one
at the time) on the front panel to set
these parameters (page 35).
Key
Allows you to transpose the BK-5 OR in
semi-tone steps up or down. See
page 44.
Backing Keyboard BK-5 OR
Parameter/Group
Explanation
Arranger Setting
This function group allows you to specify
where and how the selected rhythm
should scan the note messages gener-
ated by your playing for chord informa-
tion. See page 66.
Melody Intelligent Allows you to set the "Melody Intelli-
gence" function. See page 68. This page
can also be selected by pressing and
holding the [MELODY INTELL] button.
Save As Default
This function allows you to save all "Per-
formance Edit" settings as the new
defaults that will be loaded each time
you switch on the BK-5 OR.
'Tone Part View' parameters
This function group can be selected using [MENU] but-
ton ‰ "Performance Edit" ‰ "Tone Part View".
1.
Use the [CURSOR÷VALUE] dial and [ENTER/
SELECT] button to select the keyboard part
you want to edit (LWR, UP2, UP1).
The display shows the settings for the selected key-
board part.
2.
Use the dial to select and set the desired
parameter(s).
The following parameters are available:
Tone
Allows you to select a different Tone. See the sepa-
rate booklet for a list of available Tones and Drum
Sets. While selecting a Tone, you can press a Tone
selection button to select a different family.
Parameter
Explanation
Tone
The number of Tones depends on the
selected family.
Volume
Adjusts the volume of the selected keyboard part.
Selecting "0" means that the part is question is no
longer audible.
Parameter
Setting
Volume
0~127
r
'Performance Edit' parameters
59
Advertisement
Table of Contents
