Table of Contents
Advertisement
Rx
This parameter allows you to specify whether ("On")
or not ("Off") the selected MIDI channel should be
used to receive chord information.
Parameter
Setting
Rx
Off, On
Rx Octave
Use this parameter to transpose the notes received
on the selected MIDI channel ("Ch") in steps of one
octave.
Parameter
Setting
Rx Octave
–4~0~4
Rx Global Limit Low/High
These parameters allow you to set the note range to
be received. If not all note messages of the selected
MIDI channel should be received by the NTA "part",
set the range to the desired values.
Parameter
Setting
Rx Global Limit Low
C–~G9
Rx Global Limit High
C–~G9
NOTE
The "Limit Low" value cannot be higher than the "Limit
High" value (and vice versa).
Parameters
The following parameters are located on the display
page that can be selected using [MENU] button‰
"MIDI" ‰ "Edit System" ‰ "Parameters".
This page contains several parameters that are not
related to one another (the other MIDI pages always
concentrate on one aspect).
Part Switch
This parameter allows you to specify whether or not a
muted part should go on sending MIDI messages:
Parameter
Setting
Part Switch
Internal, Int+MIDI
Internal: A muted part can no longer be played via
the BK-5 OR's keyboard or Arranger/song player but
continues to send MIDI messages. Selecting "Internal"
and muting a part thus has the same effect as select-
ing "Local Off" (see p. 107).
Backing Keyboard BK-5 OR
Int+MIDI: A muted part can no longer be played via
the BK-5 OR's keyboard or Arranger/song player and
no longer sends MIDI messages.
Tx Velocity
Your BK-5 OR is equipped with a velocity-sensitive
keyboard and a tone generator capable of responding
to velocity messages. Use this parameter to switch
the transmission (TX) of velocity messages on or off.
If you don't select "On", specify which velocity value
to use instead of the continuous flux. The value you
set will be used for all notes sent to MIDI OUT/USB
COMPUTER.
Parameter
Setting
Tx Velocity
On, 1~127
Tx SysEx
Use this parameter to specify whether ("On") or not
("Off") the BK-5 OR should send SysEx messages.
Such messages are not standardized, so that each
manufacturer can use them ad lib for temporary (or
permanent) changes to the way a part behaves.
Effects parameters, for instance, can only be changed
via SysEx messages.
Such messages may slow down playback on external
MIDI instruments or yield no effect at all, which is
why you have the option to switch off their trans-
mission in the first place.
Parameter
Setting
Tx SysEx
Off, On
Tx Data Change
This parameter allows you to specify how the original
program changes of the songs you play back are
transmitted via MIDI. The BK-5 OR may change
sound addresses (usually CC00 and CC32 values) so
as to play back all songs with the best possible qual-
ity. If you switch this parameter on, such real-time
transformations are also transmitted via MIDI. If you
switch this parameter off, the original sound
addresses are transmitted to the receiving device.
(But the BK-5 OR's tone generator continues to
"enhance" the songs you play back.)
Parameter
Setting
Tx Data Change
Off, On
Octave Tx
The "Octave Tx" parameter can be set to Absolute or
Relative. You may have noticed that if you assign a
bass sound to the UP1 or UP2 part in SPLIT mode, the
notes are transposed to allow you to play meaningful
bass lines using the UP1/2 part. "Relative" means that
this internal (and automatic) transposition is trans-
lated into MIDI note numbers.
r
MIDI parameters
113
Advertisement
Table of Contents
