Table of Contents
Advertisement
Backing Keyboard BK-5 OR
Menu options
The display shows a confirmation message.
If you don't want to define the current settings as
the default state, rotate the [CURSOR÷VALUE] dial to
select "NO", then press the [ENTER/SELECT] button.
The BK-5 OR then returns to the "Compressor" page.
NOTE
There is only one "User" memory for your own settings. By
saving new settings, you therefore overwrite the previous
ones.
NOTE
When you switch on the BK-5 OR, it automatically loads
the "User" settings.
Equalizer
To edit the Equalizer parameters, use [MENU] button ‰
"Mastering Tools" ‰ "Equalizer".
The equalizer has the same function as the TREBLE, MID
and BASS knobs on a mixer: it allows you to color the
sound, or to apply tonal corrections.
1.
Select a keyboard part, an SMF song or a
rhythm and start playback.
2.
Set the "Switch" parameter to "On" to acti-
vate the equalizer.
The equalizer is now active and will affect the key-
board parts and SMF song or rhythm playback.
(Select "Off" to switch the equalizer back off.)
3.
Use the [CURSOR÷VALUE] dial to select the
"Preset" parameter, then press the [ENTER/
SELECT] button.
4.
Rotate the [CURSOR÷VALUE] dial to select
one of the available presets.
The available presets are:
1. Flat
4. Jazz
2. Rock
5. Classic
3. Pop
76
5.
If none of the preset memories contains the
settings you need, you can change the fol-
lowing parameters by first pressing the
[ENTER/SELECT] button and then using the
[CURSOR÷VALUE] dial.
Parameter
Level
Gain
High
Frequency
High Gain
6. Standard
7. User
Mid Fre-
quency
Setting range
Explanation
0~127
Use this parameter to set
the equalizer's input
level. This may be neces-
sary when the level of
the input signals is so
high that the sound dis-
torts.
NOTE
Do not set this param-
eter to "0" if the equal-
izer is switched on,
because doing so
means that the key-
board parts, SMF song/
rhythm is/are no
longer audible.
–9~0~9dB
Use this parameter to
correct the level at the
equalizer's outputs. If
the settings of the
remaining parameters
lead to a significantly
lower level, select a posi-
tive value. If your set-
tings lead to a
significantly higher level,
select a negative value.
"0" means that the level
is neither boosted nor
attenuated.
2000~
Allows you to set the
12000Hz
cutoff frequency of the
high band (this is a
shelving filter).
–15~15dB
Use this parameter to set
the level of the selected
"High" frequency. Posi-
tive values boost
(increase the volume of)
that frequency band,
negative values cut
(attenuate) it.
200~8000Hz
Allows you to set the
cutoff frequency of the
middle band (this is a
peaking filter).
Advertisement
Table of Contents
