Roland BK-5OR Owner's Manual page 60

Backing Keyboard BK-5 OR
Menu options
Reverb Send
Use this parameter to set the reverb send level (i.e.
the amount of effect that should be added).
Parameter Setting
Reverb Send 0~127
Chorus Send
Use this parameter to set the chorus send level (i.e.
the amount of effect that should be added).
Parameter Setting
Chorus Send 0~127
Panpot
Use this parameter to change the stereo placement
of the selected keyboard part. "L63" means "hard left"
and "R63" represents "hard right". Choose "0" if the
sound should be at the center of the stereo image.
Parameter Setting
Panpot L63~0~R63
Key Touch (velocity sensitivity)
The BK-5 OR's keyboard is velocity sensitive, allowing
you to control the timbre and volume of the key-
board parts by varying the strength with which you
strike the keys.
1.
If you want to edit this setting, you have to
press the [ENTER/SELECT] button to select
the "Key Touch" page.
2.
Use the [CURSOR÷VALUE] dial to select and
set the desired parameter, then press the
[ENTER/SELECT] button and rotate the
[CURSOR÷VALUE] dial.
The following parameters are available:
Parameter Setting range
Curve High, Medium,
Low, Fixed*
60
1.
Explanation
"High": Select this set-
ting for maximum
expressiveness. Even
small variations of the
force with which you
strike a key produce
audible changes. The
trade-off is, however,
that you have to strike
the keys forcefully to
reach the maximum
volume.
Parameter Setting range
Min Value 1~127
Max Value 1~127
Fixed value* – 1~127
[*] This parameter can only be edited if the "Curve" parameter is
set to "Fixed".
Eq Part Edit
If you also want to edit the parameters of
the equalizer, you have to rotate the
[CURSOR÷VALUE] dial and press the [ENTER/
SELECT] button to select the "Eq Edit Part"
page.
Explanation
"Medium": Medium
velocity sensitivity.
The keyboard
responds to velocity
changes, but the max-
imum volume can be
obtained more easily
than with "high". (This
is the default setting.)
"Low": Select this set-
ting if you are used to
playing on an elec-
tronic organ or if you
do not want velocity
changes to bring
about major volume
changes.
"Fixed": Select this
setting if all notes you
play on the keyboard
should have the same
velocity value. When
you set this parame-
ter, the "Fixed value"
field can be edited
This parameter allows
you to set the smallest
velocity value with
which you can trigger
the selected part.
This parameter allows
you to set the highest
velocity value with
which you can trigger
the selected part.
Allows you to set the
value when "Curve" is
set to "Fixed".