External Lyrics; Performance Edit' Parameters; Tone Part View' Parameters - Roland BK-5 Owner's Manual

Backing Keyboard BK-5
Menu options
The internal display now shows the lyrics of the
selected song (4 lines at a time) and the chords of the
song (only for SMF files).
4.
At the end of the song, press and hold the
[EXIT] button to return to the main page.
NOTE
The internal display always shows four lines of lyrics and
the chord symbols (this cannot be changed).

External Lyrics

This is, in fact, a switch that allows you to cancel ("Off")
or activate ("On") the display of song lyrics on an exter-
nal screen.

'Performance Edit' parameters

The following parameters can be set for each Perfor-
mance memory:
Parameter/Group Explanation
Tone Part View This is where you can edit settings
related to Tones. See page 56.
Tone Part MFX Contains the effects parameters for the
keyboard parts (LWR, UP2, UP1). See
page 60.
Rhythm Parts This group contains all parameters of the
rhythm parts. See page 61.
Split This parameter allows you to change the
split point, i.e. the separation between
the lower and upper keyboard zones. See
page 61.
Key Allows you to transpose the BK-5 in
semi-tone steps up or down. See
page 41.
Arranger Setting This function group allows you to specify
where and how the selected rhythm
should scan the note messages gener-
ated by your playing for chord informa-
tion. See page 62.
Melody Intelligent Allows you to set the "Melody Intelli-
gence" function. See page 64. This page
can also be selected by pressing and
holding the [MELODY INTELL] button.
56
Parameter/Group Explanation
Save As Default This function allows you to save all "Per-
formance Edit" settings as the new
defaults that will be loaded each time
you switch on the BK-5.

'Tone Part View' parameters

This function group can be selected using [MENU] but-
ton ‰ "Performance Edit" ‰ "Tone Part View".
1.
Use the [CURSOR÷VALUE] dial and [ENTER/
SELECT] button to select the keyboard part
you want to edit (LWR, UP2, UP1).
The display shows the settings for the selected key-
board part.
2.
Use the dial to select and set the desired
parameter(s).
The following parameters are available:
Tone
Allows you to select a different Tone. See page 119
for a list of available Tones and Drum Sets. While
selecting a Tone, you can press a Tone selection but-
ton to select a different family.
Parameter Explanation
Tone The number of Tones depends on the
selected family.
Volume
Adjusts the volume of the selected keyboard part.
Selecting "0" means that the part is question is no
longer audible.
Parameter Setting
Volume 0~127
Reverb Send
Use this parameter to set the reverb send level (i.e.
the amount of effect that should be added).
Parameter Setting
Reverb Send 0~127
Chorus Send
Use this parameter to set the chorus send level (i.e.
the amount of effect that should be added).
Parameter Setting
Chorus Send 0~127