Input Source Selection (Component, Rgb Scart 21-Pin) - Sanyo PLC-XU106 Owner's Manual

Video Input

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation
Choose Computer 1(Component) or Computer 1(Scart) by pressing the INPUT button on the top control or
pressing the COMPUTER 1 or the COMPONENT button on the remote control.
Before using INPUT button, correct input source should be selected through Menu operation as described
below.
Remote Control
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point
2
Use the Point
then press the Point
3
Use the Point
RGB(Scart) and then press the SELECT button.
When the input source is coming from video
Component
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.47).
40
COMPUTER 1 button
Computer 1 (RGB)
Computer 1 (Scart)
COMPONENT button
Computer 1
(Component)
buttons to select Input and
or the SELECT button.
buttons to select Computer 1 and
button.
buttons to select Component or
Top Control
INPUT button
Input Menu
Computer 1(RGB) /
(Component) / (Scart)
Computer 2(RGB)
Video
S-video