Assembly And Installation Of Transmission - Cub Cadet 7530 Maintenance Manual

5
5.8

Assembly and Installation of Transmission

Follow the procedure for removal and disassembly of transmission in the reverse order for assembly and installation
and the below procedure for reference for adjustment and maintenance at assembly.
1 Assembly of Transmission
1. Clean each part sufficiently and assemble.
2. Make sure that snap rings for each part are securely attached.
3. Apply oil to the O-ring and needle bearing for assembly.
4. Apply lithium grease to the oil seal for assembly.
5. Assemble as shown in the drawing for the spur gears with specified mounting direction (edgy or chamfered
side).
6. Apply liquid packing (Threebond #1208D) to the matching face of mission case for assembly.
5.8.1 Assembly of Transmission Case Assembly (HST Specification)
HST unit
4WD shaft
36T 30T
18T
35T
Liner "A"
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Transmission
40T
32T
Grease
25T
34T
GZ3W24-042
75
Sub gearing
low-speed-N-intermediate-N-high-speed
30T
23T
14T
22T
36T
30T
18T
25T
34T
35T
Liner "A"
25T
31T
2WD 4WD
1. Adjust the endplay shown in the drawing to be
within 0.05 to 0.20mm {0.002 to 0.008in} with
liner "A".
Item Thickness
0.15 {0.006}
0.2 {0.008}
Liner "A"
0.4 {0.016}
0.8 {0.031}
Shaft
GZ3W24-041
(Unit: mm {in})
Parts No.
0731 0002 501
0731 0002 502
0731 0002 504
0731 0002 508