Cub Cadet 7530 Maintenance Manual page 152

7
7.3.2 Installation of Front Axle Assembly
1 Assemble the front axle assembly to the chassis.
1. Make sure that the propeller shaft and spline boss for joint smoothly slides.
2. After assembling, adjust the toe in to 0 to 10.0mm {0 to 0.39in} and steering angle (external angle) to 54°. (Set
the length of cutting angle adjusting bolt to 20.0mm {0.787in}.)
Reference) Refer to the Section 8 - 3 Assembly and Installation of Steering for toe in adjustment.
3. After removing the bleeder plug on both left/right sides and supplying oil, install the bleeder plug.
4. Supply the front axle oil.
Gear Oil SAE #80, 4.0L {1.1gal}
2 Assembly of Propeller Shaft
Pinion shaft 6T
1. In case the spline boss for joint does not slide smoothly, adjust with the shim "K".
Item
Shim "K"
2. Apply lithium grease to the spline and assemble shafts.
3. Select the position (gap) where the backlash of the joint becomes minimum for C-ring at joint and assemble it.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Front Axle
Grease
Front joint
C-ring
Thickness
0.40 {0.016}
1.00 {0.039}
3.20 {0.13}
110
A
Propeller shaft
A
Usable Limit
1030 2141 001
1030 2142 001
1030 2143 001
Grease
Rear joint
4WD shaft
GZ3W26-022
(Unit: mm {in})