Cub Cadet 7530 Maintenance Manual page 201

No.
1 Bolt
2, 3, 4 Bolt
5 Bolt
6 Plug
7, 8 Plug
9 Sleeve
10, 11 Screw
5 Assembly of Hydraulic Pipes
1. Misalignment at joint by hose shall be within 2mm {0.079} on both sides of pipe.
2. Apply some oil to the O-ring and take caution not to fill out at assembly.
3. Apply some lubricant, MoS2-P, to the driving shaft spline for pump.
4. Handle with caution for entry of foreign matters to the pipe or mounting holes, etc. at assembly and
disassembly.
5. Make sure there is no oil leakage after assembly.
6. Follow below for assembly of the filter.
1) Clean the mounting face and apply some oil to the packing face of cartridge for lubrication.
2) Tighten with torque at 14.7 to 19.6 N•m {150 to 200kgf•cm, 10.85 to 14.5lbf•ft}.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Hydraulic System
Parts Size
M8
M10
M14
G1/4
G3/8
M8
27
Torque (N•m {kgf•cm, lbf•ft})
19.6 to 21.6 {200 to 220, 14.46 to 15.9}
39.2 to 44.1 {400 to 450, 28.9 to 32.5}
118 to 132 {1200 to 1350, 86.8 to 97.6}
34 to 39 {350 to 400, 25.3 to 28.9}
49 to 59 {500 to 600, 36.2 to 43.4}
84 to 93 {850 to 950, 61.5 to 68.7}
15 to 18 {150 to 180, 10.85 to 13}
1