Table of Contents
Advertisement
Telephone settings
information about Tones and Cadences on Avaya CS 1000, see Avaya
Features and Services Fundamentals (NN43001-106).
Attention: Cadence Mode is applicable to traditional DECT systems
only (based on DMC cards). If you enable or disable
Cadence Mode for a SIP DECT solution, there is no impact.
To cause your DECT handset to use the ring cadences configured on
your CS 1000 system, you must activate Cadence Mode on your DECT
handset. This allows the PBX system to control the on and off phases of
the ringing cycles on the handset. If Cadence Mode is disabled on your
handset, the handset continuously plays its ringing melody on any
incoming call, irrespective of the Tones and Cadences configuration on
your CS 1000 system.
To activate Cadence Mode on your handset, perform the following steps:
Cadence Mode
Select
On
Off
Select
191
1. Open the
Sounds and alerts
in
"Accessing the Sounds and alerts menu"
(page
177).
2. Press the
Up
Mode.
3. Press the
Select
4. Press the
Up
5. Press the
Select
6. Press the
Clr
idle display.
menu using the steps
or
Down
key to highlight
soft key.
or
Down
key to select
soft key to apply the changes.
key one or more times to return to the
Cadence
On
or Off.
Advertisement
Table of Contents
