Wan - TP-Link TL-R470T+ User Manual

Note:
1) If you change the IP address of the LAN, you must use the new IP address to login to the
router.
2) If the new LAN IP Address you set is not in the same subnet, the IP Address pools in the
DHCP sever will not take effect, until they are re-configured. Besides this, the Virtual Server
and DMZ Host may change accordingly at the same time; you'd better re-configure it as well.
4.3.3

WAN

Choose menu "Network→WAN", you can configure the IP parameters of the WAN on the screen
below.
The Router provides six connection types for WAN to connect to the Internet, they are "Dynamic
IP", "Static IP" , "PPPoE", "BigPondCable" , "L2TP" and "PPTP". For configuring the WAN, you
should select the connection type firstly according your needs.
1. Dynamic IP
If you aren't given any login parameters and IP information, please select Dynamic IP (shown in
Figure 4-5), then the router will automatically get IP parameters from your ISP. Click the Renew
button to renew the IP parameters from your ISP. Click the Release button to release the IP
parameters.
TL-R470T+ Load Balance Broadband Router User Guide
17