TP-Link TL-R470T+ User Manual page 55

For example: if you want to block the PCs on your LAN from accessing websites
www.xxyy.com.cn, www.aabbcc.com
for other websites, you can configure as follows.
Step 1: Enable the "Firewall" and "Domain Filtering" on the Firewall screen (show in Figure
4-30).
Step 2: Select the Deny to access websites specified by rules as the Default Domain
Filtering Rules on the Firewall screen (show in Figure 4-30).
Step 3: Click Add New.../Modify shown in Figure 4-34, you will see a new screen shown in
Figure 4-35.
Step 4: Enter the "Effective time" that the rule will take effect, enter the "Domain Name" as
shown in Figure 4-35.
Step 5: Select the "Status" for the rule as shown in the next screen.
Step 6: Finally, click Save to make the rule take effect.
Step 7: Go to Step 2 to complete the other rules continually.
After you finish the configurations, you will see the rules in the table below:
Note:
Before adding an IP Address Filtering entry, you should enable the Firewall and the IP Address
Filtering function first (shown in Figure 4-30).
Other configurations for the entries as shown in Figure 4-31:
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.
Click the Disable All button to disable all the entries.
Click the Delete All button to delete all the entries.
Click the Previous button to view the information in the previous screen, click the Next button to
view the information in the next screen.
TL-R470T+ Load Balance Broadband Router User Guide
and websites with end of
Figure 4-35
Figure 4-36
49
.net on the Internet, while no limit