Wan Service - TP-Link TDW8968V3 User Manual

TD-W8968
DSL Link Type: Select a DSL Link Type which is provided by your ISP. The options include
EoA (it is for PPPoE, IPoE, and Bridge), PPPoA (PPP over ATM) and IPoA (IP over ATM).
Encapsulation Mode: The mode of the data processing over the Link Type you have
selected. Uses the default setting, if you are not sure.
Service Category: Select the type of the service assigned by your ISP in the drop-down list.
The default type is UBR Without PCR.
Note:
Enabling packet level QoS for PVC improves performance for selected classes of applications.
While QoS consumes system resources; therefore the number of PVC(s) will be reduced. Besides
this, it cannot be set for the connection type of CBR and Real-time VBR. If you select the QoS
service, the Quality of Service menu will be added to the Web-based Utility, the detailed
configuration will be described in
4.5.1.2 ETH Interface
If your modem router works on Wireless Router Mode, choose "Advanced Setup" "Layer2
Interface ETH Interface", you can see ETH WAN interface on the screen below.
4.5.1.3 USB 3G Interface
If you enable 3G as backup access or your modem router works on 3G Router Mode, choose
"Advanced Setup" "Layer2 Interface" "USB 3G Interface", you can see USB 3G interface
status on the screen below.

4.5.2 WAN Service

Choose "Advanced Setup" "WAN Service", and you will see the WAN Port Information Table in
the screen similar to Figure 4-7, which describes the WAN port settings and the relevant
manipulation to each interface. After you add a new Lay2 Interface, please follow the instructions
below to complete the further configuration of WAN Interface. There are five different
configurations for the connection types, which are PPPoE, IPoE, Bridge, PPPoA, and IPoA. You
can select the corresponding types according to your needs.
300Mbps Wireless N USB ADSL2+ Modem Router User Guide
4.4.9 Quality of
Figure 4-5
Figure 4-6
19
Service.