Verifying the Port Mapping Configuration
Example Port Mapping Configuration Steps
The following steps provide a quick tutorial that configures the port mapping session shown in the
diagram on
page
9-5.
1
Create two port mapping sessions on Switch A using the following commands:
-> port mapping 1 user-port 2/1-2 network-port 1/1-2
-> port mapping 2 user-port 3/1-3 network-port 1/3
2
Configure session 1 on Switch A in the unidirectional mode using the following command:
-> port mapping 1 unidirectional
3
Enable both the sessions on Switch A using the following commands:
-> port mapping 1 enable
-> port mapping 2 enable
Similarly, create and enable a port mapping session 1 on Switch D by entering the following commands:
-> port mapping 1 user-port 2/1-2 network-port 1/1
-> port mapping 1 enable
Verifying the Port Mapping Configuration
To display information about the port mapping configuration on the switch, use the show commands listed
below:
show port mapping status
show port mapping
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
page 9-6
Displays the status of one or more port mapping sessions.
Displays the configuration of one or more port mapping sessions.
OmniSwitch 6600 Family Network Configuration Guide
Configuring Port Mapping
April 2006