Verifying the Spanning Tree Configuration
Verifying the Spanning Tree Configuration
To display information about the Spanning Tree configuration on the switch, use the show commands
listed below:
show spantree
show spantree ports
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show spantree and show spantree ports commands is also
given in
"Example Network Configuration Steps" on page
page 5-32
Displays VLAN Spanning Tree information, including parameter values
and topology change statistics.
Displays Spanning Tree information for switch ports, including parame-
ter values and the current port state.
5-30.
OmniSwitch 6600 Family Network Configuration Guide
Configuring Spanning Tree Parameters
April 2006