Operation; Operating The Bc10 Basic Controller; General; Menu Structure Of The Bc10 Basic Controller - Buderus Logamax plus GB142-24 Servicing Instructions

4

Operation

4.1

Operating the BC10 basic controller

4.1.1

General

The boiler is equipped with an control unit, the basic controller
BC10. The BC10 allows you to operate the boiler.
 Briefly press on the control panel cover to open it
(see fig. 3).
The basic controller BC10 (see fig. 2) is located on the left side in
the drawer.
On the right side of the drawer there's space for a RC control unit.
4.1.2 Switching the heating system on and off
Switching on the heating system
 Set the main switch on the BC10 basic controller to position "1"
(On).
Switching off the heating system
 Set the main switch on the BC10 basic controller to position "0"
(Off).
4.2

Menu structure of the BC10 basic controller

The menu structure of the boiler can be viewed on the BC10 using
c
the "Reset" , "Chimney sweep
fig. 2, pos. 9, 10 and 11) buttons and the display indication (see
fig. 2, pos. 4).
The menu structure consists of 4 menus, schematically
represented on the following pages using structure diagrams:
– "Flue gas test" menu (page 10)
– "Service Mode" menu (page 11)
– "Manual Operation" menu (page 12)
– "Settings" menu (page 12).
Logamax plus GB142-24/30/45/60 - We reserve the right to make any changes due to technical modifications!
d e
" and "Service " (see
fig. 3 Opening the control panel
Operation 4
9