IPoE Mode (In the following example to configure a IPoE WAN interface,
the VDSL WAN is used.)
Scenario:
The P2812HNU-51c is a DHCP client in routing mode.
b. IPoE Mode
1.
Go to Network > WAN > Internet Connection.
2.
Click Add
3.
Select the Layer 2 interface for this service, e.g. "ptm0/(0_0_1)"
4.
Click Next
5.
Select the WAN service type, i.e. "IP over Ethernet"
6.
Enter the Service Description, or use the default values.
7.
Configure Rate Limitation, or set up VLAN ID if needed.
All contents copyright (c) 2009 ZyXEL Communications Corporation.
P-2812HNU-51C Support Notes