Vt 100 Terminal Emulation - ADTRAN Express 3010 Manual

After installation is complete, the Express 3010/3110 resets the ISDN
line for a clean start. Therefore, the PWR/LINE LED may not be on
solid (indicating link up) for a few more seconds. In the few cases
where the procedure does not succeed, a window will pop up,
prompting you to enter the SPIDs.

VT 100 TERMINAL EMULATION

The Express 3010/3110 can be configured using any communications
package supporting VT 100 terminal emulation. Instructions for VT
100 configuration are given in VT 100 Configuration on page 2-8 and in
Chapter 3, Application Configuration. The main branches of the VT 100
menu tree and their hot keys (the keys you press to go to a particular
menu) are as follows:
Menu:
CONFIG (Ctrl + C)
DIAL
STATUS
TEST
Ensure that the communications package is configured to pass these
Control Sequences through to the Express.
To exit a menu, you can press Ctrl + X. The Ctrl + X command also
places the unit back on-line if a call is connected.
Some features in the Express 3010/3110 do not immediately take ef-
fect upon selection. This prevents unintentional reconfiguration of the
Express 3010/3110 during an active call. Items such as Protocol and
Call Type take effect only at the beginning of a new call.
61200239L1-20 Express 3010/3110 User Manual
Hot Keys:
(Ctrl + D)
(Ctrl + V)
(Ctrl + T)
Chapter 2. Installation
2-7