Table of Contents
Advertisement
Chapter 2. Installation
Windows NT 3.51 Users
1.
Locate the modem.inf file. This file is normally located in the
c:\winnt35\system32\ras directory. See the Windows NT
documentation for instructions on installing the Remote Access
Service.
2.
To recover your files in case of a user mistake, create a backup of
the modem.inf file.
3.
Using Notepad, open the adtran.inf file (on the Express CD).
4.
Copy the contents of the adtran.inf file into the Windows clip-
board.
5.
Open the modem.inf file.
6.
Paste the contents of the clipboard (adtran.inf) to the end of the
modem.inf file.
7.
Save the new altered modem.inf and close the file.
8.
Restart the system.
MACINTOSH INSTALLATION INSTRUCTIONS
Hardware Installation
1.
With the Macintosh's power off, connect the EIA232 serial port
on the Express to an available communications port on the
Macintosh.
Be sure to use a Macintosh high-speed modem cable. Macintosh
high-speed modem cables are available at any electronics store that
carries Macintosh equipment.
2.
Plug the Express's AC power cord into the port labeled PWR.
Plug the other end into a 120 V electrical outlet. The Express is
now powered on.
3.
Plug the RJ-45 connector (large end) of the RJ-45-to-RJ-11 tele-
phone cable into the jack labeled ISDN on the rear of the Express.
4.
Plug the RJ-11 connector (small end) of the RJ-45 to the RJ-11 tele-
phone cable into the ISDN telephone wall jack.
5.
Power on the Macintosh.
2-4
Express 3010/3110 User Manual
61200239L1-20
Advertisement
Table of Contents
