Basic Telephone Service; Supplementary Voice Services; Call Waiting; Conference Calling - ADTRAN Express 3010 Manual

BASIC TELEPHONE SERVICE

In addition to the computer connection, two analog devices such as a tele-
phone, Fax, modem, answering machine, or caller ID box can be connect-
ed using the two POTS interfaces on the rear panel (RJ-11 jacks labeled 1
and 2 with an illustration of a telephone above the jack).

Supplementary Voice Services

Supplementary services such as call forwarding, caller ID, call return,
call holding, three- or six-way conference calling, call transfer, call re-
jection, and call waiting are fully supported by the Express 3010/3110
on a touch-tone telephone. These services are available only if includ-
ed in the ISDN line configuration and are implemented using the stan-
dard commands provided by the telephone company.

Call Waiting

Call Waiting permits one voice call to be placed on hold while answering
another voice call. Use the flash-hook to place the active call on hold and
answer an incoming call. Hanging up terminates both calls. The call wait-
ing tone can be disabled and enabled on a per-call basis. To disable call
waiting (using a touch-tone phone), press *70. To enable call waiting,
hang up. (The Express defaults to call waiting.)

Conference Calling

Conference Calling (also known as three-way calling) permits a con-
versation between three parties, each at different locations.
After establishing a voice call, flash-hook to put the first party on hold
and receive a second dial tone. Dial the second party. Flash-hook
again to conference the two calls.
When connecting to a National ISDN 1 switch, call conferencing, message
waiting, and call transferring are assigned a unique feature identifier
number. This number may not be the same in all areas. S-registers 90
through 93 contain the feature identifier numbers for conference and
transfer. If these features do not work, contact your ISDN provider.
61200239L1-20 Express 3010/3110 User Manual
Chapter 2. Installation
2-5