Caveats in Cisco IOS XE 3.6S Releases
CSCty73528
•
Symptoms: The router displays core dump files.
Conditions: Occurs when you perform an RSP switchover when CEF routes are configured.
Workaround: There is no workaround.
CSCty74058
•
Symptoms: The router sends traffic for virtual circuits (VCs) over Gigabit Ethernet interfaces
instead of MPLS-TP tunnels.
Conditions: Occurs when you perform an interface module OIR and the VCs are configured with a
preferred path as the MPLS-TP tunnel.
Workaround: There is no workaround.
CSCty74062
•
Symptoms: The router does not pass MLP traffic.
Conditions: Occurs when you perform an RSP switchover with an existing MLP configuration.
Workaround: There is no workaround.
CSCty74129
•
Symptoms: A REP topology may reconverge during an RSP switchover. The consoles displays REP
no-neighbor messages.
Conditions: Occurs when you configure REP between two Cisco ASR 903 Routers and you
perform an RSP switchover.
Workaround: There is no workaround.
CSCty77704
•
Symptoms: CFM traceroute fails between two CE devices.
Conditions: Occurs under the following conditions:
–
–
–
Workaround: Disable CFM on the Cisco ASR 903 Router acting as a PE device.
CSCty79273
•
Symptoms: Multicast replication does not occur on all BDI interfaces on a given trunk EFP.
Conditions: Occurs under the following conditions:
–
–
–
Workaround: There is no workaround.
CSCty80326
•
Symptoms: The router displays an Eamapper error.
Conditions: Occurs under the following conditions:
–
–
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
26
There is a CFM xconnect between higher-level MEPs
The MEPs are between CE devices
The CE devices are in a different domain.
The router is configured with 63 or more BDIs
The BDIs are configured as OIFs on a trunk EFP.
The port on which the EFP is configured is in a multicast group.
The router is configured with a port channel interface with 2 member links.
The port channel
Chapter Restrictions and Caveats in Cisco IOS XE 3.6S Releases
OL-26630-12