Resolved Caveats-Cisco Ios Xe Release 3.10.2S - Cisco ASR 900 Series Release Notes

Asr 900 series
Hide thumbs Also See for ASR 900 Series:
Table of Contents

Advertisement

Chapter
Resolved Caveats—Cisco IOS XE Release 3.10.2S
This section documents the issues that have been resolved in Cisco IOS XE Release 3.10.2S.
OL-26630-12
CSCum47925
Symptom: SSO convergence time of ~0.9 sec is observed with 100m SFP.
Conditions:This issue occurs when VPLS VC and EVC BD exists on the access.
Workaround: There is no workaround.
CSCum79011
Symptom: Pending objects take a long time (approx 30 min) to clear on the router.
Conditions: This issue occurs when QoS-policy is applied on member-link and services like
psuedowire, HSRP on BDI are configured on the port-channel.
Workaround: There is no workaround.
CSCun70703
Symptom: Interface module goes to out of service during ISSU and when FPGA is changed.
Conditions: This issue occurs on performing ISSU when there is a IM FPGA change between the
releases.
Workaround: Perform the following:
Perform IM FPGA upgrade using the package file.
Proceed with ISSU.
CSCuf35542
Symptom: PFM fails for about 5minutes after OIR on the master.
Conditions: This issue occurs after OIR is triggered two times on the master
Workaround: Wait for 5-6 minutes
CSCuh06123
Symptom: QL-mapping displays incorrectly on master.
Conditions: This issue occurs when QL value is configured first and then PTP master is configured
Workaround: Reconfigure QL values or reload the router.
CSCuh49073
Symptom: OSPF does not come up when PIM is enabled on the VPLS core interface.
Conditions: This issue occurs when PIM is enabled on the VPLS core interface.
Workaround: There is no workaround.
CSCuh54159
Symptom: Packet drops are seen under QOS policy map attached on the multilink bundle for traffic
rate less than bundle capacity
Conditions: This issue occurs when unexpected packet drops are seen for QOS for traffic rates less
than bundle bandwidth. After reloading the router with QOS policy attached on bundle, packet
prioritization into different queues with differing bandwidth profiles occurs.
Workaround: Remove and reattach the policy map on the bundle
Caveats in Cisco IOS XE 3.10S Releases
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asr 903

Table of Contents