Cisco ASR 900 Series Release Notes page 296

Caveats in Cisco IOS XE 3.11S Releases
Symptom: Crash observed on the router after unconfiguring 1000 psuedowires.
Conditions: This issue occurs after unconfiguring 1000 psuedowires at a stretch.
Workaround: There is no workaround.
CSCui30240
•
Symptom: SPA is not initialized messages are seen on bootup.
Conditions: This message is seen post bootup as well during shutdown command followed by a no
shutdown command is issued on the controller. This issue occurs on remote PE reload.
Workaround: Disable console logging.
CSCui34041
•
Symptom: Traffic is not flowing for one of the prefix.
Conditions: This issue occurs when the MAX MPLS label of that template is assigned to that prefix.
Workaround: Disable and enable that prefix.
CSCui34989
•
Symptom: OC-3 IM IOMD crash is seen post SSO.
Conditions: This issue occurs after SSO is performed.
Workaround: There is no workaround.
• CSCui47776
Symptom: Virtual circuit receive counters do not increment after SSO is performed.
Conditions: This issue occurs when 1000 VCs are configured and SSO is performed.
Workaround: There is no workaround.
CSCui52938
•
Symptom: Layer 3 interface adjacency is incomplete.
Conditions: This issue occurs after the RSP is removed from the router.
Workaround: There is no workaround.
CSCui55567
•
Symptom: Traffic convergence for OC-3 IM with TDM features such as serial, MLPPP or POS is
high after RSP SSO.
Conditions: This issue occurs after SSO is performed.
Workaround: There is no workaround.
CSCui75901
•
Symptom: Sync packets are not sent at a regular interval by the router and inter-packet gap is not
within the standard range.
Conditions: This issue occurs under normal conditions.
Workaround: There is no workaround.
• CSCui97872
Symptom: The controller remains in disabled state after enabling the license.
Conditions: This issue occurs on performing IM OIR or framing.
Workaround: Disable the license and enable it.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
8
Chapter
OL-26630-12