Cisco ASR 900 Series Release Notes page 77

Chapter Restrictions and Caveats in Cisco IOS XE 3.6S Releases
Workaround: In order to achieve marking and policing at the ingress we can use a conditional
policer but this is not supported at the egress.
• CSCtx60094
Symptoms: Type 1 MVPN routes are not created.
Conditions: This issue is observed when the IP address of a loopback interface is changed.
Workaround: Create a dummy neighbor under the address-family ipv4 mvpn configuration or the
address-family ipv6 mvpn configuration. Alternatively, unconfigure and reconfigure the MDT
group under the VRF configuration.
• CSCtx73691
Symptoms: Standby gateway starts forwarding packet for some of the HSRP sessions.
Conditions: This is seen on flapping the HSRP session.
Workaround: There is no workaround.
CSCtx75877
•
Symptoms: ICMP unreachable messages are sent even though route for destination ip is present in
routing table. There is no ACL applied on any of the interface.
Conditions: This is seen on reload with VRRP configuration present on incoming interfaces.
Workaround: There is no workaround.
CSCtx77233
•
Symptoms: The router displays an error message similar to the following:
FMFP-3-OBJ_DWNLD_TO_CPP_FAILED: SIP0: fman_fp_image:
failed
Conditions: Occurs when you shut down a backup tunnel and shut down an FRR-protected
interface, disabling TE tunnels.
Workaround: None; the error does not impact traffic forwarding.
CSCtx75877
•
Symptoms: ICMP unreachable messages are sent when a route for the destination ip address exists
in the routing table. There is no ACL applied on any of the interface.
Conditions: Occurs under the following conditions:
–
–
–
Workaround: There is no workaround.
CSCtx77233
•
Symptoms: The router displays an error message similar to the following:
FMFP-3-OBJ_DWNLD_TO_CPP_FAILED: SIP0: fman_fp_image:
failed
Conditions: Occurs when you shut down a backup tunnel interface and a FRR-protected interface,
bringing down MPLS TE tunnels.
Workaround: There is no workaround; the error does not appear to impact traffic forwarding.
OL-26630-12
There is a VRRP configuration applied to incoming interfaces.
There are not ACLs applied on any interface.
Your reload the router.
frr 0x1029 download to CPP
frr 0x1029 download to CPP
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.6S Releases
19