Cisco ASR 900 Series Release Notes page 163

Chapter
Symptom: Multicast traffic is not bridged with REP.
Conditions: This issue occurs when multicast traffic flows on the REP configured interfaces.
Workaround: Unconfigure and configure REP on the interfaces.
CSCuf61024
•
Symptom: TDM and OC-3 IM continuously crashes enters inserted state after ISSU is performed.
Conditions: This issue occurs after ISSU is performed.
Workaround: There is no workaround.
CSCuf74113
•
Symptom: Interface mode cannot be entered for serial interfaces. Error messages are displayed.
Conditions: This issue occurs after creation of serial interfaces.
Workaround: There is no workaround.
• CSCuf80482
Symptom: Configuration synchronization fails from active to standby IOMD.
Conditions: This issue occurs on IM OIR.
Workaround: Perform a soft reset of the IM or the interface flap.
CSCuf86247
•
Symptom: SNMP MIB variables related to BDI counters do not function properly.
Conditions: This issue occurs when you use SNMP MIB variables related to BDI interface counters.
Workaround: There is no workaround.
CSCuf89725
•
Symptom: After IM OIR the remote MEP shows BLK state on CFM offload.
Conditions: This issue occurs when CFM MEP is configured an IM OIR is performed.
Workaround: There is no workaround.
CSCug05491
•
Symptom: The router drops traffic on VPLS circuits.
Conditions: This issue occurs when the following is performed:
–
–
–
Workaround: There is no workaround.
CSCug05647
•
Symptom: Interface counters do not get updated with IP traffic.
Conditions: This issue occurs when performing a back-to-back ping on the connected interfaces.
Workaround: Perform a router reload.
CSCug39899
•
Symptom: Traffic stops flowing through QinQ BDI interface after ARP times out and ARP is
removed by shutting the BDI.
OL-26630-12
Configure REP with or without VLAN load balancing
Configure VPLS VFI on the VLANs
Issue an stateful switchover (SSO).
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.8S Releases
11