Cisco ASR 900 Series Release Notes page 117

Asr 900 series
Hide thumbs Also See for ASR 900 Series:
Table of Contents

Advertisement

Chapter
CSCud07642
Symptom: The ASR 903 router is unable to pass traffic to the ASR 9000.
Conditions: Occurs with a clear-channel ATM over MPLS configuration using AAL0
encapsulation.
Workaround: Enable MPLS control-word on the ASR 9000.
CSCud09632
Symptom: The router does not correctly update the J0 byte on the OC-3 or OC-12 interface module.
Conditions: Occurs in a back-to-back configuration with two ASR 903s passing SONET traffic.
Workaround: There is no workaround.
CSCud15785
Symptom: The router experiences flapping on REP connections.
Conditions: Occurs under the following conditions:
Workaround: Increase the REP timer to above 500 milliseconds or disable the MAC limiting
feature.
CSCud15841
Symptom: The clear ip mroute * command causes resource leakage.
Conditions: Occurs when you issue the clear ip mroute * command while IP multicast is enabled.
Workaround: Reload the router.
CSCud17457
Symptom: The router drops IP multicast traffic.
Conditions: Occurs when you perform the following actions:
Workaround: Reload the router or issue a stateful switchover (SSO).
CSCud23698
Symptom: The router stops applying classification and marking for a class.
Conditions: Occurs when you remove a priority level while using dual priority for the
class-map.
Workaround: Remove and reattach the policy-map on the interface.
CSCud28982
Symptom: The router does not process egress CoS marking on an Ethernet service instance.
Conditions: Occurs when you configure QoS on an Ethernet service instance that is a member of a
bridge-domain and uses dot1q encapsulation.
Workaround: There is no workaround.
OL-26630-12
MAC limiting is enabled and a MAC address is at the maximum value
REP is configured with a 200 millisecond LSL ageout timer
Configure EFPs as members of a port channel containing a single interface.
Remove the configuration for the EFPs
Remove the interface from the port channel
Add the EFPs back onto the interface
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.7S Releases
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asr 903

Table of Contents