Cisco ASR 900 Series Release Notes page 282

Caveats in Cisco IOS XE 3.10S Releases
Workaround: There is no workaround.
CSCuf43275
•
Symptom: The router does not detect traffic through GLC-FE-100EX and GLC-FE-100ZX
transceivers.
Conditions: The router does not support traffic through GLC-FE-100EX and GLC-FE-100ZX
transceivers.
Workaround: There is no workaround.
CSCuf43992
•
Symptom: The router crashes if you configure local span.
Conditions: This issue is observed when you configure local span on the router.
Workaround: There is no workaround.
CSCuf44077
•
Symptom: The show interface command output shows incorrect speed values after performing an
SSO.
Conditions: This issue is observed when you use a 100M SFP.
Workaround: There is no impact on functionality. Reset the hardware module to resolve this issue.
CSCuf57632
•
Symptoms: When you reload the router, the device may not be able to load the startup configuration
from NVRAM.
Conditions: This issue is sometimes observed when you reload the router.
Workaround: Reload the router again.
CSCuf65012
•
Symptom: When you perform an IM OIR on slot 4, the router may display syslog messages from
the GigabitEthernet 0/5/0 port.
Conditions: This issue is observed when you perform an IM OIR on slot 4 and Slot 5.
Workaround: There is no workaround.
CSCuf79364
•
Symptom: When you try configure speed on the interface on the standby machine, it does not accept
the command.
Conditions: This issue is observed after you insert a new IM and GE-T connector when router is
running.
Workaround: Reload the router before configuring the speed.
CSCuf79504
•
Symptom: When you use the shutdown and no shutdown commands multiple times on the
controller, ATM VC creation on the standby RSP fails.
Conditions: This issue is observed when you use the shutdown and no shutdown commands
multiple times on the controller on active RSP.
Workaround: There is no workaround.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
28
Chapter
OL-26630-12