Accessing The Web Interface; Changing The Language - KVH Industries FB250 User Manual

Accessing and navigating the web interface

Accessing the web interface

To access the web interface, do as follows:
1. Connect your computer to the terminal.
2. Start up the terminal.
For details, see Getting started on page 19.
3. Open your browser and enter http://ut.bgan or the IP address of the
terminal in the address bar.
If your connected computer is set up to obtain a DNS server address
automatically, this name is translated into the local IP address of the
terminal. The default IP address of the terminal is http://192.168.0.1.
Note
If the IP address has been changed and you do not have the new
address, you can temporarily set the IP address to the default value
by pressing the Reset button next to the SIM slot in the connector
panel of the terminal. You can then access the web interface and
change the IP address.
Note that if you do not change the IP address, the default IP address
will only be valid until the terminal is powered off. Then the terminal
returns to the IP address from before the Reset button was pressed.
For further information on the Reset button, see Reset button on
page 214.

Changing the language

When you have access to the web interface, if you want to display a different
language than English, select SETTINGS > LANGUAGE from the left menu,
select a language from the list and click Apply. For further information, see
Selecting the language on page 155.
Chapter 4: Using the web interface
Introduction 73