Remote Activation - KVH Industries FB250 User Manual

Chapter 4: Using the web interface
2. Select whether remote access should be Enabled or Disabled for the web
server and/or for AT commands.
3. Type in the Incoming port numbers to use for the web server and for AT
commands.
Note
4. Under TRUSTED IP ADDRESSES, type in the IP addresses of the devices you
want to give access to the terminal.
5. Click Apply.
If Static IP is included in your airtime subscription, we recommend using this
static public IP address for the terminal in order to provide easy access to the
terminal.
Note
You must activate a connection in the terminal before you can access
the terminal.
After preparing the terminal and activating the connection you can access the
terminal from one of the trusted IP addresses, using the incoming port defined
in the Incoming port field.
• For information on how to prepare the terminal for remote activation of a
data connection, see the next section.
• For information on how to access the terminal, see Accessing the terminal
from a remote location on page 64.
• For information on how to set up a static IP address, refer to step 7 on
page 136 in the section Editing a network user group.

Remote activation

If you want to remotely control the terminal, you must first activate a
connection. You can do this by sending an SMS to the terminal. The SMS
activation is always protected by a password. You can set up the terminal to
176
The port number must be available at your service provider. For
AT commands, use 5454 if available. If 5454 is not available you
must use port forwarding to the port number you are using.
Administration