Battery Over-Heating; Bike Not Stable - Life Fitness Lifecycle 9100 Service Manual

Lifecycle 9100 and 9500HR Series Exercise Bikes
TROUBLESHOOTING GUIDE
Malfunction Probable Cause Corrective Action
During exercise program, Pedaling too slowly Pedal faster than 45 RPM.
pedaling is insufficiently
easy, not providing
Program level doesn't Select higher level.
adequate resistance.
challenge user abilitv
Loose wire connections Disconnect then, reconnect connections.
Worn or damaged harnesses
Inspect wire harnesses. Replace wom or
damaged harness.
Malfunctioning Display Console
Test with substitute Display Console. Replace
malfunctioning Display Console.
Malfunctioning Alternator
Test with substitute Altemator Control Board.
Control Board Replace defective board.
Malfunctioning Alternator Test Alternator output or, test with substitute
Altemator. Replace malfunctioning Altemator.
Refer to Alternator Voltage Test.
Alternator Belt excessively Inspect belt deflection. Adjust as necessary.
loose
Alternator Belt Deflection: 1/4 inch (6mm)
Drive Belt excessively loose Inspect Belt. Replace Belt.
Battery over-heating during Battery Wires incorrectly
Inspect connections: red wire to positive (+)
exercise program.
connected lead; black wire to negative (-) lead.
Worn Battery Wires
Inspect Wires. Replace Wires or harness.
Battery leads grounding upon Inspect leads. Replace battery.
frame
Malfunctioning Display Console Test with substitute Display Console. Replace
malfunctioning Display Console.
Malfunctioning Alternator Test with substitute Alternator Control Board.
Control Board Replace defective board.
Exercise Bike not stable Stabilizer Foot Pads not Adjust Foot Pads.
upon floor.
adjusted correctly
Floor surface not level Position Exercise Bike upon level surface.
Stabilizer Bar not attached
Tighten attaching hardware.
firmly to frame
Wheel(s) darnaged Replace darnaged wheel(s).
Frame damaged Contact Customer Support Services.
6
•
•