Life Fitness Lifecycle 9100 Service Manual page 66

- - _ . -
. _ - - - - - - - - - - -
Lifecycle 9100 and 9500HR Series Exercise Bikes
How To..•REMOVE AND REPLACE HOUSING
Tools Required: Phillips screwdriver
•
1. With a phillips screwdriver, remove the two exterior screws on the user right hand side handlebar neck shroud
(LC9500HR only). Once removed the user left handlebar neck shroud can removed. Loosen and remove the
inner neck shroud screw and remove the user right side neck shroud.
2. To remove the LEFT PEDAL, small hole-side of HOUSING, place a 5/8 inch open-end wrench on the PEDAL
BOLT and tum the wrench clockwise. To remove the RIGHT PEDAL, sprocket side, place a 5/8 inch open-end
wrench on the PEDAL BOLT and tum the wrench counterclockwise.
•
.......
.......
.......
Torque
6-12 ft. Ibs.
..- {l)) · . . . . . .
····~·r
Torque
6-10 in. Ibs.
(Typical)
.......
LC9500HR
3. With a phillips screwdriver, remove the screw on the user right side seat post shroud. Once removed,
separate the two neck shrouds.
4. With a Phillips screwdriver, remove the remaing 9 screws on the user right hand shroud. Swing the
SPROCKET side (right) CRANK ARM up to the 2 o'clock position and guide the HOUSING up and over the
CRANK ARM.
5. Once the user right shroud is removed, remove the 3 inner screws holding on the left shroud. Swing the small-
hole side (left) CRANK ARM down to the 4 o'clock position and guide the worn HOUSING out and over the
CRANK ARM.
6. Reverse this procedure for reassembly. •
20