Lifecycle 9100 and 9500HR Series Exercise Bikes
How To...REMOVE AND REPLACE THE TELEMETRY RECEIVER
Tools Required: flat head screwdriver, Phillips screwdriver
1.
Remove the DISPLAY CONSOLE. Refer to SEE HOW TO.. .in this section.
2.
Remove the neck shroud under HOUSING. Refer to SEE HOW TO...in this section.
3.
Remove the decal located on the front of the telemetry housing with a flat head screwdriver.
4.
Using your Phillips head screwdriver loosen the two screws and remove the cover.
5.
Pull the receiver out of the jack and replace with a new RECEIVER.
6.
Reassemble in the reverse order.
•
3 Pin Connector
Foam Cover
Receiver
(Red dot m u s t - - - - - - -
face user)
Cover
Cover Screws
24
Receiver Connector
•
•