Overview Of Setup Mode (Led) - Fujitsu DL7600 User Manual

USING SETUP MODE
OVERVIEW OF
SETUP MODE (LED)
<< FUNCTION >>
SAVE&END MENU1 MENU2
HEX-DUMP V-ALMNT INITIAL
5-4
When you enter setup mode, the following <<FUNCTION>> menu is
printed:
HARDWRE ADJUST CONFIG
Table 5.1 summarizes the purpose of each function.
Table 5.1 Setup Mode Functions
Function
SAVE & END Exits setup mode and saves any changes made while
in setup mode.
MENU1 and Assigns print features to MENU1 and MENU2 on the
MENU2 printer control panel.
HARDWRE Changes the printer hardware options.
ADJUST Changes the print position adjustment options.
CONFIG Changes the configuration options.
GAP-ADJ Adjust the gap between the print head and printing
paper.
DEFAULT Resets factory defaults in MENU1 and MENU2.
INITIAL Resets factory defaults in MENU1, MENU2,
HARDWRE, ADJUST, CONFIG, GAP-ADJ.
LIST Prints a list of all currently selected options.
SELF-TST Runs the self-test.
HEX-DUMP Prints hex dumps.
V-ALMNT Checks and corrects vertical print alignment.
To select a function from the <<FUNCTION>> menu:
1. Repeatedly press the "TEAR OFF" or "LOAD" button to
position the cursor on the left edge of the aluminum print guide
at the function you require.
2. Press the
function has items and options, the printer prints the first item
and its options. The MENU1, MENU2, HARDWRE, ADJUST,
CONFIG, and GAP-ADJ functions contain items that have
selectable options. The other functions have neither items nor
options.
GAP-ADJ DEFAULT
Purpose
button or the button to select the function. If the
LIST SELF-TST
User's Manual