Fujitsu DL7600 User Manual page 138

USING SETUP MODE
5-44
Table 5.7 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Options
Items
<//S//>
DISABLE
ENABLE
<FCNT-PE>
TRACTOR
EDGE
<RCNT-PE>
TRACTOR
EDGE
Description
Effectiveness of the Cut Sheet
Selection command (//S//).
Makes the command ineffective.
Makes the command effective.
Note: The Cut Sheet Selection
command (//S//) changes the
paper source to the paper table
and waits for manual insertion
of a cut sheet.
Detection of end of front continuous
forms.
Paper end is detected by the sensor on
the tractor unit.
Paper-end unprinted area:
Continuous forms: About 101 mm
Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area: About 4
mm for both continuous forms
Detection of end of rear continuous
forms.
Paper end is detected by the sensor on
the tractor unit.
Paper-end unprinted area:
Continuous forms: About 157 mm
Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area:
About 4 mm for both continuous
forms
User's Manual