Fujitsu DL7600 User Manual page 49

User's Manual
4. Examine the self-test page. It should look like the sample on the
below.
Check that printing is uniform and that there are no light, dark,
or smudged areas. If the print quality is good, go to step 5.
Otherwise, try to correct the problem as follows:
•
Make sure that the ribbon is installed correctly.
•
Load a new sheet of paper.
•
Repeat the self-test procedure.
5. To exit the self-test mode, press the ONLINE button. The
printer will return online.
NOTE
The printer can also print a special "demo pattern" that illustrates
some of the printer's capabilities. To print the demo pattern:
1. Load continuous forms (wider than 254 mm (10 inches)).
2. Turn the printer off .
3. While pressing the FRONT DIR button, turn the printer back
on.
The printer will start printing the demo pattern.
4. The demo pattern stops printing after one page. To pause or
restart the demo during printing of a page, press the ONLINE
button.
Sample self-test page
SETTING UP
2-19