User's Manual
Table 5.6 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST
Options
Items
<CNT-LFT>
-10/90, ..., 0/90,
..., 10/90
<CUT-LFT>
-10/90, ..., 0/90,
..., 10/90
<FCNTADJ>
-14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
<RCNTADJ>
-14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
<FCNTAJL>
-14/360, -9/360, -
4/360, 0/360
4/360, 9/360,
14/360,
GRAPHIC(*1)
USING SETUP MODE
Description
Fine-tunes the left print start position
for continuous forms.
Moves the position left or right in
increments of 1/90 inch
(0.28 mm).
Fine-tunes the left print start position
for single sheets.
Moves the position left or right in
increments of 1/90 inch
(0.28 mm).
Compensates for the forms feed error
accumulated through feeding of front
continuous forms.
Compensates for the forms feed error
accumulated through feeding of rear
continuous forms.
Compensates for the forms feed error
accumulated through feeding of front
continuous forms. (Last page)
5-37