Image Controls Menus; Horizontal Shift Menu; Vertical Shift Menu - Extron electronics RGB 302 User Manual

____ The following menus require use of the cursor keys to

Image Controls Menus

____ If the "Shift Disabled" message is displayed, the unit

Horizontal Shift Menu

Vertical Shift Menu

Extron RGB 302/304 Universal Interface • User's Manual
make adjustments or selections. As a matter of
convenience (but excluding the use of "hot keys"),
pressing either the
same effect. Similarly, pressing either the
key will have the same effect.
From the Default Cycle menus, press
to advance to the Image Controls menus. The
image which the RGB 302/304 displays on a
monitor or projector screen can be adjusted
through these menus. Press
Horizontal Shift menu (see note below) or
to advance to the Sync Controls menus.
has been set to the Digital Display Sync
Processing mode. Refer to "Digital Display
Sync Processing" earlier in this chapter.
The Horizontal Shift menu moves the
displayed image left or right on the monitor/
projection screen. From the default cycle, you
can go directly to this menu by pressing either
the
setting is "CENTER".
While observing the video screen, use the
cursor keys
horizontal centering. There are 255
incremental steps for this control.
When the adjustment is complete, release the
cursor key and press
Vertical Shift menu, or press
to the Sync Controls menus, or allow the time-
out to occur to save any changes.
The Vertical Shift menu moves the displayed
image up and down on the presentation
screen. From the default cycle, you can go
directly to this menu by pressing either the
or
"CENTER".
Chapter 3 • Front Panel Menus
or key will have the
or "hot key". The default
and
NEXT
"hot key". The default setting is
or
MENU
to go to the
NEXT
MENU
to adjust the
to go to the
to advance
MENU
Page 3-6