Extron electronics RGB 302 User Manual page 15

100-240V
MBC
POWER
100-240V
____ The diagrams above show the front and rear panels of
Easy Setup Procedure
• Red, Green/sync and Blue, for RGB with sync on
• Red, Green, Blue and H/HV, for RGB with Composite
• Red, Green, Blue, H/HV and V, for RGB with separate
Page 2-1
0.5A
OUTPUT
R G B
50/60 Hz
AUDIO IN
ANALOG/ECL
INPUT
0.5A
OUTPUT
R G B
50/60 Hz
the RGB 302 (top pair) and RGB 304 (bottom pair).
These easy-to-follow steps describe the general setup
of the RGB 302/304. Refer to the example Application
Diagrams at the end of this chapter.
1. Turn the computer and monitor power Off.
Do not connect the RGB 302/304 power cable yet
(there is no power switch).
2. Disconnect and remove the computer's local monitor
video cable from the computer video port.
3. Connect BNC output cables from the RGB 302/304
to the data monitor/projector — all BNC outputs are
RGB analog. The BNC connectors are marked R, B,
G, H/V and V. They may be connected in any of
three ways:
Green. (3-cable hookup)
sync signals. (4-cable hookup)
Horizontal and Vertical sync signals. (5-cable hookup)
Extron RGB 302/304 Universal Interface • User's Manual
Chapter 2 • Installing the RGB 302/304
MENU NEXT
H/HV V
AUDIO
L R
OUT IN
MENU
H/HV V
AUDIO
L R
OUT
RGB 302
RS-232
MBC
POWER
ANALOG/ECL
INPUT
RGB 304
NEXT
RS-232