Table A-1 Openboot Configuration Variables Stored On The System Configuration Card - Fujitsu SPARC Enterprise T2000 Administration Manual

OpenBoot Configuration Variables Stored on the System Configuration Card (Continued)
TABLE A-1
Variable
ttya-mode
output-device
input-device
auto-boot-on-error?
load-base
auto-boot?
boot-command
use-nvramrc?
nvramrc
security-mode
security-password
security-#badlogins
68 SPARC Enterprise T2000 Server Administration Guide • April 2007
Possible Values Default Value
9600,8,n,1,- 9600,8,n,1,-
virtual- virtual-
console, console
screen
virtual- virtual-
console, console
keyboard
true, false false
0-n 16384
true, false true
variable-name
boot
true, false false
variable-name
none
none, command, none
full
variable-name
none
variable-name
none
Description
Serial management port (baud rate, bits,
parity, stop, handshake). The serial
management port only works at the default
values.
Power-on output device.
Power-on input device.
If true, boot automatically after system
error.
Address.
If true, boot automatically after power on
or reset.
Action following a boot command.
If true, execute commands in NVRAMRC
during server startup.
Command script to execute if
use-nvramrc? is true.
Firmware security level.
Firmware security password if
security-mode is not none (never
displayed). Do not set this directly.
Number of incorrect security password
attempts.