Table 1-1 Ways Of Communicating With The System - Fujitsu SPARC Enterprise T2000 Administration Manual

The serial management port (SER MGT) is the default port for accessing the system
console upon initial system installation. After installation, you can configure the
system console to accept input from and send output to different devices.
lists these devices and where they are discussed in the document.
Ways of Communicating With the System
TABLE 1-1
Devices Available
A terminal server attached to the
serial management port (SER
MGT).
An alphanumeric terminal or
similar device attached to the
serial management port (SER
MGT).
A Tip line attached to the serial
management port (SER MGT).
An Ethernet line connected to the
network management port (NET
MGT).
2 SPARC Enterprise T2000 Server Administration Guide • April 2007
During After
Installation Installation
X X
X X
X X
X X
X X
X X
X X
X X
X
X X
Further Information
"Accessing the System Controller" on
page 7
"Accessing the System Console Through a
Terminal Server" on page 10
"System Console OpenBoot Configuration
Variable Settings" on page 26
"Accessing the System Controller" on
page 7
"Accessing the System Console Through an
Alphanumeric Terminal" on page 15
"System Console OpenBoot Configuration
Variable Settings" on page 26
"Accessing the System Controller" on
page 7
"Accessing the System Console Through a
Tip Connection" on page 12
"Modifying the /etc/remote File" on
page 13
"System Console OpenBoot Configuration
Variable Settings" on page 26
TABLE 1-1