To Disable Automatic System Recovery; Obtaining Automatic System Recovery Information - Fujitsu SPARC Enterprise T2000 Administration Manual

The system permanently stores the parameter changes and boots automatically
when the OpenBoot configuration variable auto-boot? is set to true (its default
value).
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
▼

To Disable Automatic System Recovery

1. At the ok prompt, type:
ok setenv auto-boot-on-error? false
2. To cause the parameter changes to take effect, type:
ok reset-all
The system permanently stores the parameter change.
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
After you disable the automatic system recovery (ASR) feature, it is not activated
again until you re-enable it.
Obtaining Automatic System Recovery
Information
Use the following procedure to retrieve information about the status of system
components affected by automatic system recovery (ASR).
●
At the sc> prompt, type:
sc> showcomponent
In the showcomponent command output, any devices marked disabled have been
manually unconfigured using the system firmware. The showcomponent command
also lists devices that have failed firmware diagnostics and have been automatically
unconfigured by the system firmware.
Chapter 2 Managing RAS Features and System Firmware 39