Accessing The System Console Through A Terminal Server; To Access The System Console Through A Terminal Server - Fujitsu SPARC Enterprise T2000 Administration Manual

- If you intend to use Telnet to connect to the system controller:
■
sc> setsc if_connection telnet
5. Reset the system controller so that the new settings take affect:
sc> resetsc
6. After the system controller resets, log in to the system controller and issue the
shownetwork command to verify network settings:
sc> shownetwork
To connect through the network management port, use the telnet or ssh (based on
the value you provided in Step 4) commands to the IP address you specified in
Step 3
Accessing the System Console Through a
Terminal Server
The following procedure assumes that you are accessing the system console by
connecting a terminal server to the serial management port (SER MGT) of the
SPARC Enterprise T2000 server.
▼

To Access The System Console Through a Terminal Server

1. Complete the physical connection from the serial management port to your
terminal server.
The serial management port on the SPARC Enterprise T2000 server is a data terminal
equipment (DTE) port. The pinouts for the serial management port correspond with
the pinouts for the RJ-45 ports on the Serial Interface Breakout Cable supplied by
Cisco for use with the Cisco AS2511-RJ terminal server. If you use a terminal server
made by another manufacturer, check that the serial port pinouts of the SPARC
Enterprise T2000 server match those of the terminal server you plan to use.
If the pinouts for the server serial ports correspond with the pinouts for the RJ-45
ports on the terminal server, you have two connection options:
Connect a serial interface breakout cable directly to the SPARC Enterprise T2000
■
server. See
10 SPARC Enterprise T2000 Server Administration Guide • April 2007
of the preceding procedure.
"Accessing the System Controller" on page 7.