Fujitsu SPARC Enterprise T2000 Administration Manual page 86

4. Verify that the device has been removed from the device tree.
Type the following command:
# cfgadm -al
Ap_Id
c0
c0::dsk/c0t0d0
c0::dsk/c0t1d0
c0::dsk/c0t2d0
c0::dsk/c0t3d0
c1
c1::dsk/c1t0d0
usb0/1
usb0/2
usb1/1.1
usb1/1.2
usb1/1.3
usb1/1.4
usb1/2
#
Note that c0t3d0 is now unavailable and unconfigured. The corresponding
hard drive OK-to-Remove LED is lit.
5. Remove the hard drive, as described in the SPARC Enterprise T2000 Server Service
Manual.
The blue OK-to-Remove LED goes out when you remove the hard drive.
6. Install a new hard drive, as described in the SPARC Enterprise T2000 Server Service
Manual.
7. Configure the new hard drive.
Type the following command:
# cfgadm -c configure Ap-Id
For example:
# cfgadm -c configure c1::dsk/c0t3d0
The green Activity LED flashes as the new disk at c1t3d0 is added to the device
tree.
64 SPARC Enterprise T2000 Server Administration Guide • April 2007
Type Receptacle
scsi-bus connected
disk connected
disk connected
disk connected
unavailable connected
scsi-bus connected
CD-ROM connected
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
Occupant Condition
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
unconfigured unknown
configured unknown
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok