Table of Contents
Advertisement
Copying a Frequency into a Specified Channel
You can copy a frequency into a specified channel when the scanner stops on that
frequency during search mode or manual tuning. If a CTCSS or DCS code is detected on
the transmission, the detected code will be copied into the channel memory as well.
1. Press FUNC then PGM when you find a frequency. Chan Store? appears on the
bottom line. After about 1 second, the frequency to be copied flashes on the indicator.
2. Press the desired bank and the channel number where you want to store the
frequency. The display indicates the bank and channel number, and briefly displays
the frequency that is currently programmed into the selected channel. You can repeat
this step as needed until you find an acceptable destination channel. After about 1
second, the frequency to be copied flashes.
3. Press ENTER. All the conditions such as receive mode and delay condition are
copied onto the channel. Chan Store! briefly appears in the scanner's display. The
scanner automatically returns to search mode.
Note
If you try to copy a frequency that is already stored, the scanner sounds the notice
tone 3 times after you press ENTER. Dupl.f Chxxx appears at the bottom line. If
you want to copy the duplicate frequency anyway, press ENTER, or if not, press CLR
to cancel.
Copying a Frequency into a Vacant Channel in a Specified Bank
You can copy a frequency into a vacant channel in a specified bank when the scanner
stops on the frequency during search or tune mode.
1. Press FUNC then ENTER when you find a frequency you want to copy. Bank9
Store? appears in the scanner's display.
2. If you want to copy the frequency into bank 9, press ENTER. It is stored in the first
available vacant channel in the bank. Or, press your desired bank number to store,
then press ENTER to store the frequency in the selected bank. Chan Store!
appears for 2 seconds. All the conditions such as receiving mode and delay
61
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
