Charging Rechargeable Batteries - Radio Shack PRO-96 Owner's Manual

Charging Rechargeable Batteries

Your scanner has a built-in charging circuit that lets you charge nickel-metal hydride
(Ni-MH) or nickel cadmium (Ni-CD) rechargeable batteries (not supplied) while they are
in the scanner. To charge rechargeable batteries, connect an appropriate AC or DC
adapter to the PWR DC 9V jack. For best results we recommend RadioShack
rechargeable nickel-metal hydride (NiMH) 1800 mAh batteries.
!
IMPORTANT
The EPA certified RBRC© Battery Recycling Seal on rechargeable batteries indicates
RadioShack is voluntarily participating in an industry program to collect and recycle
these batteries at the end of their useful life, when taken out of service in the United
States or Canada. The RBRC program provides a convenient alternative to placing used
rechargeable batteries into the trash or the municipal waste stream, which may be illegal
in your area. Please call 1-800-THE-SHACK (1-800-843-7422) for information on
rechargeable battery recycling and disposal bans/restrictions in your area. RadioShack's
involvement in this program is part of the company's commitment to preserving our
environment and conserving our natural resources.
To charge batteries with a DC adapter from a DC power source, you must use a 9V, 300
mA DC adapter such as RadioShack Cat. No. 273-1810 and a size C Adaptaplug™
(neither supplied). Both are available at your local RadioShack store. Make sure the
adapter's voltage is set to 9V.
It takes about 16 hours to recharge fully discharged 1800 mAh NiMH rechargeable
batteries. You can operate the scanner while recharging the rechargeable batteries, but
charging takes longer.
Notes
The scanner can also charge Ni-Cd batteries. 600 mAh batteries require 6 hours and
850 mAh batteries require 8 hours to charge.
When you charge Ni-Cd batteries, do not overcharge them. Overcharging shortens
battery life.
26