Radio Shack PRO-96 Owner's Manual page 32

2. Use the number keys and ./DELAY to enter the frequency (including the decimal
point) you want to store.
If you make a mistake, press CLR to backspace and correct the incorrect digit, or
press and hold CLR for about 2 seconds to clear the entire field and start over.
3. Press ENTER to store the frequency into the channel.
4. By default, the scanner will configure the channels you enter for a two second delay
after a transmission is received. This is indicated by the D character that appears in
the top row of the display. If you do not want the scanner to pause for reply traffic
before resuming scanning operation, press ./DELAY until D is not visible in the top
line of the display.
5. If necessary, press MODE to change the receiving mode. Valid modes for
conventional frequencies include AM, FM/Digital, CTCSS and DCS. To program a
specific code for CTCSS or DCS mode, press FUNC MODE, then enter the desired
code followed by ENTER, or use the
press ENTER to store the code with the channel memory. For more information on
CTCSS and DCS programming, see "Programming channels for CTCSS and DCS
operation" on Page 42.
6. If desired, program a text tag for the channel (see "Assigning a Text Tag to a
Channel" on Page 46).
Notes
If you made a mistake in entering the frequency, Invalid Freq briefly appears and
the scanner beeps when you press ENTER. Enter the frequency again.
Your scanner automatically rounds the entered frequency to the nearest valid
frequency. For example, if you enter a frequency of 151.53, your scanner accepts it
as 151.5275. Reception of the frequency will not be adversely affected.
If you enter a frequency that has already been entered elsewhere in the same bank,
the scanner sounds an error tone and displays Dupl.f and the channel number that
has been duplicated. If the dual entry is an error press CLR and enter the correct
frequency. If the dual entry is intentional press ENTER to accept.
or keys to scroll to the desired code and
31